Venting Over Wide Ridge Beam – GreenBuildingAdvisor

Hello, we are mostly through with framing, and had a realization that we don’t have a good vent path to the ridge cap.  Our roof is carried by a girder truss that is 4 ply 2x material.  So 6″ wide.  The rafters/trusses are parallel chord 24″ deep.  The intent is to vent the sheathing and fill the remainder of the truss with dense pack.  Today the framer and I were looking at it and realized there isn’t a path past where the rafter/truss meets the beam.  Being a 6″ wide beam, it’s a little different than typical.  How would you handle this situation?  Picture is attached to show what I mean.  I’ll grab one of the actual truss when I can. 

Ideally, we would have held the beam an inch lower, but that’s in the past now.