Blog
I’m getting ready to retile my hearth, in part because I have to extend it out 7 more inches to meet code. I’d like to avoid cutting out the wood floor so plan to lay a 1/2 inch of micore 300 over the top of it, and then add cement board over the micore, and […]
Hi, doing a reno of slab on grade home in canadian climate, hot summer, cold winter, we tore out plaster walls and spray framed everywhere on lower level except furnace room which is beside my kitchen, two furnace room walls are interior two are exterior , top half of two exterior furnace room walls( above […]
Exterior 2×6 wall on post and beam frame has wet plywood and framing in places. Probably many problems with initial design.From inside out: sheetrock, 2×6 cavity with 2.5″ closed cell spray foam (at exterior side) sprayed onto: 1″ styrofoam board, 5/8 plywood, tyvek, cedar clapboards. So foam inside and out and clapboards tight to plywood. I […]
CM Revanth’s dream project of ITIs turning into ATCs to meet Industry 4.0 demands are set to be opened on September 27 The Hindu
Global Automotive Robotics Market to Reach US$ 22.49 Billion by 2033 Amid Rising EV Adoption and Industry 4.0 Integration vocal.media
Modular Automation Market Poised for Robust Growth Amid Industry 4.0 Transformation openPR.com
Hi everyone, We’re in the planning stages for our cedar siding project (Climate Zone 7A) and would really appreciate some feedback before moving forward. The goal is a durable, long-lasting, and natural finish. We’ll be doing the install ourselves with some help from friends. For reference, this is the type of look we’re hoping to […]
Good afternoon, I have a project that upon closer inspection has revealed brick nogging the entire height of the balloon framed structure; from first floor to second floor top plate. The current plan is to not remove the nogging, cost, insulate the outside of the building with a continuous layer of 5 inches of Rockwool […]