Uncategorized
Tamkeen announces support for Havelock One to adopt Advanced Industry 4.0 Technologies وكالة أنباء البحرين
For industry 4.0 readiness and to boost productivity, BGMEA signs MoU with NPO Apparel Resources
Two years ago we took advantage of our state’s efficiency rebate program to install two heat pumps in our 2,200-square foot 1978 split level in southern Maine (6A) – one up, one down in common rooms. We used them as directed by the installer, leaving them on 24/7 at a set temp. We continued to […]
Do you really want to delete the list, ? Note This won’t delete the articles you’ve saved, just the list.
We will be finishing the attic in our 1930 house in Atlanta, GA next year. Currently it is a nonvented and partially conditioned space with insufficient foam batt insulation. The roof is older clay tiles but with ice and water shield installed (i.e. a “lift and relay” was done at some point in the past) […]
Hi all- trying to diagnose how the inside end walls of my attic are wet/damp. I am perplexed. maybe Im overcomplicating. We have three “endwalls” on the house, all have a gable vent. Obvious answer would be water blowing in the gable vent, but it doesnt really line up. The wood bordering the vent is […]
Hi Folks, I’m curious if people provide any special attention to insulation around metal components in the wall assembly, particularly holddowns (i.e. simpson HDU4) and bearing plates, considering these are typically bolted into a relatively cold concrete foundation, or in my case a very cold steel trailer which my tiny house is built on. The […]
