Blog
(PDF) How manufacturing firm characteristics can influence decision making for investing in Industry 4.0 technologies ResearchGate
Unlocking value in manufacturing by taking continuous improvement to the next level IMD Business School
I’ve got a range hood that supposedly moves up to 500cfm (and a gas range so I would like the higher airflow). It’s about a 6′ duct run with 1 elbow, and I’m planning on using 6″ duct. I could upsize the duct itself, but the location where it runs through the wall is too […]
Hi all. I’m based in Central Pennsylvania and looking for insulation contractor recommendations. I’m hoping to add 2.5-3 inches of Rockwool Comfortboard as exterior continuous insulation to my ~3600 square foot home. It has relatively new siding, so it would involve removing the siding, adding the insulation, and then (hopefully adding the siding back) with […]
Hello, I’m in michigan and working on insulating my attic. My attic has no soffit vents (and no way to add them). It has gable vents and slant back vents. My upstairs has a knee wall. I need to add 18 inches of blown in insulation. I currently have 2 inches. I have been working […]
CT shoreline, Zone 5, newly renovated old home. We recently moved into our all electric renovated 1850’s home with a Mitsubishi Hyper Heat Pump and a GE ERV. For the first week, the ERV was not connected and the HP did quite well. We were extremely comfortable and even had to damper down some rooms […]
ryandefranco | Posted in General Questions on December 26, 2024 05:40pm Advice much appreciated! I’m headed to a factory tour tomorrow for a high quality prefab that I’m keen to build in 2025. The factory line has several units in various stages of completion. I’m curious what questions would you have for the (very hands […]